Aftermarket Kenworth W900L Aero custom hood with raptor fenders, and cowl induction This is a Truk-Rodz custom truck hood 100 3/4″ overall fender length – 13″ longer then standard replacement hood Cofab reinforcement used in high stress areas of hood Coremat added to suppress starbursts in high stress areas of hood E-coated or galvanized steel hardware used to resist corrosion Cormat added to fenders to suppress starbursts White sandable gel coat finish Holes pre-drilled for mounting and accessories Headlight and intake areas are cutout and pre-drilled Reinforced hinge assemblies are pre-drilled Cable catches and insulation stays included Hap 2001 Certified to fit
Fits curved windshield model only 127″ BBC Custom design with non functional cowl induction Both air in-takes are cutout Turn signal holes not drilled Check wheel clearance prior to painting Verify fit on truck before painting Sand and prime hood before painting Painted parts are non-returnable> Hood can be modified to fit metton replacement with following modifications 2 rear snubbers K273-c-180, 2 hood tilt springs L71-1002 (available here) , insulation kit K344-1134
Two year limited against manufacturing defects or inner structure failure. Warranty covers hood only. Supplier identification number will be inside each hood for warranty administration. Because of the nature of open molded fiberglass Jones Performance cannot warranty gel-coat cracks. This is also known as starburst or spider cracking. Our experience has shown us that forklifts are generally the biggest culprits, it should be noted, if the forklift forks do not go all the way through the hood (rear to front) do not use forklift to move hood. Guarantee hood to fit
K1461326, K1461295, K1461325
NA
JP-K29K
100
81
86
601
300
18650